UCi KM12 Part-Fingerless Mechanics Gloves - Pack of 10

UCi KM12 Part-Fingerless Mechanics Gloves - Pack of 10

The KM12 is a close-fitting mechanics glove with a split layout: the thumb, index and middle finger are cropped to fingertip length, while the remaining two fingers are fully covered. That gives maximum dexterity where fine control is needed and cover everywhere else. It is intended for general handling in dry conditions.

Key features

• Cropped fingertips: Thumb, index and middle finger are cut to half length for precise handling of small parts and fixings.
• Padded palm: Foam padding across the palm adds comfort and a degree of protection.
• PU reinforcement: Polyurethane reinforcement in the wear areas helps extend the life of the glove.
• Neoprene cuff: The cuff is neoprene with a Velcro adjuster to hold the glove close at the wrist.
• EN 388 tested: Scores 2120 under EN 388:2003 and 2120X under EN 388:2016.

Typical uses

Assembly, maintenance and general handling in dry conditions where direct fingertip control is useful. The cropped digits leave the fingertips unprotected, so confirm the style against your risk assessment before issuing it.

Specification

• EN 388:2003: 2120
• EN 388:2016: 2120X
• PPE Category II
• Colour: black
• Sizes: 7, 8, 9, 10, 11
• Sold in packs of 10 pairs, each pair in a retail polybag